|
Unidirectional Link Detection (UDLD) is a data link layer protocol from Cisco Systems to monitor the physical configuration of the cables and detect unidirectional links. UDLD complements the Spanning Tree Protocol which is used to eliminate switching loops. : * Unidirectional Link Detection (UDLD) is one of two major features (UDLD and loop guard) in Cisco Switches to prevent Layer 2 loops. : * Spanning-Tree Protocol (STP) resolves redundant physical topology into a loop-free, tree-like forwarding topology via blocking one or more ports. : However, Unidirectional Link failure can cause " traffic blackholing" and loop in the Switch topology. : * In order to detect the unidirectional links before the forwarding loop is created, UDLD works by exchanging protocol packets between the neighboring devices. : * In order for UDLD to work, both switch devices on the link must support UDLD and have it enabled on respective ports. ==Description== If two devices, A and B, are connected via a pair of optical fibers, one used for sending from A to B and other for sending from B to A, the link is bidirectional (two-way). If one of these fibres is broken, the link has become one-way or unidirectional. The goal of the UDLD protocol is to detect a broken bidirectional link (e.g. transmitted packets do not arrive at the receiver, or the fibres are connected to different ports). For each device and for each port, a UDLD packet is sent to the port it links to. The packet contains sender identity information (device and port), and expected receiver identity information (device and port). Each port checks that the UDLD packets it receives contain the identifiers of his own device and port. UDLD is a Cisco-proprietary protocol. Switches from 3Com and its Enterprise division H3C have a similar feature called Device Link Detection Protocol (DLDP). Switches from Extreme Networks have a similar feature called Extreme Link Status Monitoring (ELSM). Switches from NORTEL/AVAYA have a similar feature called Link-state Tracking. Similar functionality in a standardized form is provided as part of the Ethernet OAM protocol that is defined as part of the Ethernet in the First Mile changes to 802.3 (previously 802.3ah). D-Link has their DULD feature built on top of Ethernet OAM function. Brocade devices running Ironware support a proprietary form of UDLD. The need for UDLD has been eliminated when operating over 10GbE, as per 802.3ae/D3.2, when a fault is detected in the physical link: * The local device signals local fault is signaled by PHY * The local device ceases transmission of MAC frames and transmits remote fault * The remote device receives remote fault and stops sending frames and continuously generates idle frames 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Unidirectional Link Detection」の詳細全文を読む スポンサード リンク
|